The Platform Cable USB II cable optimizes direct programming of third-party SPI flash memory devices and indirect programming of SPI or parallel NOR flash memory devices via the FPGA JTAG port.In addition, Platform Cable USB II is a cost effective tool for debugging embedded software and firmware when used with Xilinx applications such as the Embedded Development Kit and ChipScope Pro Analyzer.
Xilinx Usb Jtag Cable Upgrade To AndPlatform Cable USB II is an upgrade to and backwards compatible with Platform Cable USB.
It has industry-leading performance and is compatible with Full Speed (USB 1.1) and Hi-Speed (USB 2.0) ports. Xilinx Usb Jtag Cable Free Xilinx ISEThe programmer is for Xilinx CPLD and FPGA programming using the free Xilinx ISE WebPACK software, e.g. If your PC does not have a parallel port then you will need to use a device such as the Amontec JTAGkey (see also JTAGkey CPLD programming ) or other Xilinx compatible USB programming device. The KiCad source files for this schematic as well as the PCB can be found below. A 14-way ribbon cable with a IDC connector on each end is required for connecting the programmer to the target CPLD or FPGA board. A cable for connecting the programmer to the PC parallel port is also required. Xilinx Usb Jtag Cable Download Contains TheThis download contains the source files for the KiCad project with circuit diagram and PCB in KiCad format. One to connect the programmer to the PC parallel port and the other to connect the programmer to the target board. Now solder the wires to the 25-pin male connector shown in the diagram. Glue from a hot-melt glue gun can also be used to provide strain relief for the wires from the cable where they connect to the PCB.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |